|
- Pencil
- Jigsaw - this is needed to cut the boards to size
HINT When cutting the board, you should turn it upside down as it is easier to
cut and also prevents the board from chipping.
- Hammer - this is used to tap the boards in
HINT It is very important to check your instructions, as sometimes the click system
is used on the short side as well as the long side.
- Square - this is used to make sure your boards are cut in a straight line
- Tapping Block - this is used on the short side of the board if there are any small gaps
HINT This tool is not used if the short side is a click system
- Pull Bar - this is an extension for the tapping block
|
